5
• The appliance should not be installed in bathrooms, very
wet rooms or in rooms that may contain explosive or
caustic gases.
• Check to see if your appliance has a single inlet valve,
this can only can be connected to the cold water supply.
If the appliance has a double inlet valves then it should
be correctly connected to the hot water and cold water
supply.
• Please note: The plug must be accessible after installation
• The appliance must not be installed behind a lockable
door, a sliding door or a door with a hinge on the opposite
side to that of the washer dryer.
• The appliance shall not be installed at a humid place.
Risk of damaging appliance!
• This appliance is design for domestic use only. It is not
suitable for commercial use.
• This appliance designed for use with textiles marked as
suitable for machine washing, rinsing and drying of textile
products marked accordingly.
• Do not climb up and sit on top cover of the appliance.
• Do not lean against machine door.
• When transporting or handling the appliance make sure:
a)That the transport bolts have been reinstalled into the
machine by an authorized person.
b)Make sure that any water that has accumulated in the
machine has been drained out.
c)Please handle the appliance carefully. Never hold any
protruding part of the product whilst lifting and the door
cannot be used to handle or lift the appliance when
moving it.
SAFETY INSTRUCTIONS
To Next Page
Loading...