7
Quick Start Guide – For iPhone/iPad
1. Unplug & disconnect any transmitters (TX).
2. Plug in the receiver (RX) to your TV, monitor, or
projector via HDMI.
3. Connect the USB-C port of the receiver (RX) to a
USB port or power supply for power (required).
4. Ensure the receiver (RX) is in “PC/HDMI/AirPlay”
mode. (At the top of the screen, it should say
“PC/HDMI/AirPlay Mode.”) If not, press the button
on the receiver (RX) once to switch to
“PC/HDMI/AirPlay” mode.
5. Connect your iPhone/iPad to the WiFi network
shown on the top of your TV screen. (For
example, SSID: RXxxxxx, Password: 12345678).
6. Open the Control Center / System Preferences on
your iPhone/iPad to enable AirPlay / Screen
Mirroring. Connect to the “RX4K-XXXXX” device.
To Next Page
Loading...