Clearlight SANCTUARY 3 - Page 75

76
SANCTUARY C
14 - CONNECT HEATERS IN ROOF
Assembly Instructions Cont’d
1. Locate the “trap” doors that open in the wood
roof.
2. Connect the cables under the trap door to
the same colored connector in the roof (e.g,
black/white, red/black, yellow/black, etc.)
3.
Connect the green ground wire that come
out of the side wall to the green ground wire
that is in the wood roof. Push the wiring
inside the roof area and close the roof door
compartments.
4. In the left side wall compartment, there will
be two connectors: 1) Heater connector. 2)
Keypad connector. The heater connector is a
two wire connector. The keypad connector is
a seven wire connector.
BE SURE TO MATCH THE COLORS IN THE CONNECTORS.
THE BLACK WIRE SHOULD MATCH UP WITH THE BLACK WIRE, ETC.
1. Locate the door handle.
2. Attach the door handle using the enclosed screws.
15 - INSTALLING DOOR HANDLE
Note: If you are using a tablet or smartphone to control your sauna, the door handle will act as
both the door handle and tablet/smartphone holder when the door is closed.