Clevo W540EU - Removing the Wireless LAN Module and Keyboard

Disassembly
Removing the Wireless LAN Module and Keyboard 2 - 15
2.Disassembly
Removing the Wireless LAN Module and Keyboard
1. Turn off the computer, turn it over, remove the battery (page 2 - 5) and the component bay cover (page 2 - 8).
2. The Wireless LAN module will be visible at point on the mainboard and keyboard ribbon cable under the Wire-
less LAN module (Figure 11a).
3. Carefully disconnect the cable , and then remove the screw
(Figure 11b)
4. The Wireless LAN module (Figure 11c) will pop-up, and you can remove it from the computer and the keyboard
ribbon cable will be visible at point .
5. Careful not to bend the keyboard ribbon cable . Disconnect the keyboard ribbon cable from the locking collar
socket (Figure 11d).
1
2
3
4
5
6
7
b.
c.
a.
2
3
4
1
4
d.
5
6
7
7

Touchpad Cable
The touchpad cable is underneath
the keyboard cable. When disassem-
bling the mainboard, the touchpad ca-
ble must be disconnected.

4.Wireless LAN Module
•1 Screw
Figure 11
Wireless LAN
Module and
Keyboard Removal
a. Locate the WLAN.
b. Disconnect the cable
and remove the screw.
c. The WLAN module will
pop up.
d. Disconnect the keyboard
ribbon cable from the
locking collar socket.
Note: Make sure you
reconnect the antenna
cable to the “1 + 2”
socket (Figure 11b).