appliance is not in contact with walls or with any hot element
(compressor, condenser). Observe the installation
recommendations.
• The appliance should not be placed close to radiators or
cooking hot plates or gas rings.
• Check that electrical sockets remain accessible when the
appliance is installed.
• When positioning the appliance, ensure the supply cord is not
trapped or damaged.
Power saving
To limit the electricity consumption of your appliance:
✓ Install it in an appropriate place (see “Installation
instructions”).
✓ Leave the doors open as little time as possible.
✓ To ensure that the appliance operates properly, clean the
condenser regularly (see “Maintenance”).
✓ Regularly inspect the door seals and ensure that they are still
closing properly. If this is not the case, contact your after-
sales service.
✓ The combination of shelves is recommended for energy to
be used as efficiently as possible by the refrigeration unit.
Any change to this arrangement may impact the energy
consumption of the device.
✓ The appliance's thermostat is electronic and allows you to set
the temperature between 5 and 20 degrees.
For wine storage, it is recommended that you set your
appliance to 12 degrees.
This temperature can be adapted according to the type of
wine stored.
Setting the temperature above 12 degrees will reduce the
To Next Page
Loading...
Need help?
General
