Clint FREYA

21
DOWNLOAD FIRMWARE INSTALLING FIRMWARE
1. Go to www.clintdigital.com and
download the newest rmware available
for FREYA.
2. When download is complete
copy and paste FREYA.fw from your
download folder over to an empty USB
memory stick.
3. While the le is being copied,
power on FREYA by pressing the
PLAY/PAUSE button.
4. When FREYA is fully booted up
(usually after 15-20 secs.), insert the
USB stick into the USB port on FREYA.
Note: Make sure FREYA is connected to
a power outlet so the speaker does not
power down in the middle of the update.
5. Press and hold the “Volume +” and
“Mute” simultaneously for 4 secs.
6. Release buttons and wait. Watch
the LED’s carefully and do not turn off
power or disconnect USB memory stick
during update process.
7. All ve LED will blink every second
indicating update process is ongoing.
8. When the update is nished FREYA
will reboot (the four white LED’s will
ash rapidly).
Hold for 4 sec.
Insert USB memory
stick here.
All LEDs will ash
This quick guide explains how to upgrade the
rmware (software) of your FREYA speaker
This quick guide explains how to upgrade the
rmware (software) of your FREYA speaker