CLIVET CONTROL4 NRG - Heat Pump System Management; Heat Pump Operation Settings

To Next Page

To Previous Page

M0CZ00007-03

HEAT PUMP

SET HEAT PUMP OPERATION

Information displayed:

 supply water temperature

 supply water setpoint

 return water temperature

 operation status (heating/cooling/off)

 compressor (% capacity)

 signal power

 components found in the system (radiators, fan coils and

radiant panels) and relative status (enabled / excluded).

2 - Automatic operation:

The heat pump is used to produce both air-conditioning system

water and domestic hot water.

3 - For domestic hot water only:

The heat pump is used only to produce domestic hot water.

4 - Deactivate the heat pump:

The heat pump is switched off

5 - Distribution:

Displays the components in the system.

The operation of single components of the system can be enabled or

excluded:

select 6, 7 or 8 to Exclude / Enable

Example

6 - Radiators:

Enabled

7 - Radiant panels:

Excluded

8 - Terminals:

Enabled

select 1

select 5