CLOVER A1c • 10 •
8. Installation
Overview
This section provides detailed installation instructions for the CLOVER A1c. You must
follow the installation steps correctly to ensure proper installation, operation, and service.
Place the system where it will not be subjected to extreme temperature variations. Avoid
proximity to open windows, direct sunlight, ovens, hot plates, open burners, radiators
and dry ice baths.
Do not place the CLOVER A1c on the same bench with a source of vibration.
Provide bench space large enough to allow free air circulation around the system - 8cm
(3 inches) on all sides.
Unpacking the System
Your CLOVER A1c is delivered in 1 shipping carton.
1. Carefully remove the contents of the shipping carton.
2. Inspect the carton and system for visible signs of damage.
3. If damage to the system exists, immediately file a complaint with the carrier.
4. Make sure all items are included with your system, and keep them for future use.
CAUTION
Do not drop or handle the system roughly. This can disturb internal calibrated optics
and electronics or cause other damages.
Always handle the system with care. The CLOVER A1c is a prescision system and
must be handled accordingly.
Connect the System Power
1. Ensure that the system power button is in the off position.
2. Connect the power cord to the system and to an appropriate, grounded AC electrical
outlet.
Installing Connections
12
3
45
System Connections:
1. Power Button
2. DC 9 V
3. USB port
4. Barcode Scanner port
5. Thermal Printer port (Serial port RS 232)
To Next Page
Loading...
Need help?
General