19
Personal safety equipment
Your device at a glance
►P.3, item1
1. Rollers
2. Blower nozzle
3. Suction tube
4. Grip for front hand
5. On/Off switch
6. Grip for rear hand
7. Adjustment lever (blowing, vacuuming)
8. Catch-sack
Scope of delivery
• Instructions for use
• Leaf blower/vacuum
• Catch-sack
• Shoulder strap
Assembly
►P.3, item2
1. Fit the two suction pipes sections together and
screw tightly.
2. Insert the suction pipe into the device and screw
into place.
3. Fit the castors to the suction pipe and screw into
place.
4. Hook the shoulder strap onto the device and
screw the eye closed.
5. Place the nozzle of the collection bag into the
vacuum device and screw tightly in place.
Operation
Check before starting!
Check the safety equipment and the safe condition
of the device.
– Check all parts to make sure they fit tightly.
– Check whether there are visible defects: broken
parts, cracks, etc.
Attaching the extension cable
►P.4, item3
– Plug the unit plug into the connector of the
extension cable.
– Feed the extension cable through the strain relief
mechanism(9) as shown.
Adjusting the device
– Set adjustment lever(7) to vacuum[ ] or
blow[ ].
– When using as a leaf vacuum: Insert the collec-
tion bag(8) as shown into the device and ensure
that it clicks into place (►P.4, item3).
Starting the device
– Switching on: Press the On/Off switch(5).
– Switching off: Release the On/Off switch(5).
Cleaning and maintenance
Cleaning the device
• Brush off coarse dirt.
• Wipe down the device with a slightly damp cloth.
• Clean the catch-sack regularly
Storage, transport
Storage
• Store the device in a dry place.
• Before each storage, the catch-sack must be
cleaned.
Transport
• Secure the device against slipping.
• If possible, use the original packaging for dis-
patching.
Faults and remedial measures
When something isn’t working…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Please
consult the following table before contacting the
vendor. You will save yourself a lot of trouble and
possibly money too.
When working with the device, wear eye
and ear protection.
Wear sturdy shoes when working with the
device.
Wear protective gloves when working with
the device.
Wear tightly fitting clothing when working
with the device.
Note: If one of the parts should be missing
or damaged, please contact the vender.
DANGER! Risk of injury! The device must
only be put into operation if no faults are
found. If any part of the device is defective,
it must be replaced before the next use.
Note: Work with leaf blowers/vacuums
may not be performed during normal quiet
hours.
DANGER! Risk of injury! Make sure that
unauthorized persons do not have access
to the device!
DANGER! Risk of injury! Improperly per-
formed repairs can lead to the device not
functioning safely. This endangers yourself
and your environment.
Fault/malfunction Cause Remedial measure
Motor not running. No mains voltage? Check cable, plug, socket and fuse.
Cable faulty? Contact your local vendor.
GB
Laubblaeser_Elektro_302137.book Seite 19 Freitag, 1. Juli 2016 12:28 12
To Next Page
Loading...