GB
21
– Take regular breaks and move your hands at the
same time to promote circulation.
Personal protective clothing
An overview of your unit
P. 3, item 1
1. Stirrer basket
2. Mixer shaft
3. Tool receiving socket
4. Revolution regulator
5. Handle
6. Switch lock
7. On/Off switch
Scope of delivery
• Paint and cement stirrer
• Mixing paddle
• Mixer shaft
• Operating instructions
Installation
Mounting the stirrer basket
– Screw the mixing shaft (2) to the tool holder (3).
– Counter hold the tool holder using a 22 AF open-
ended spanner and tighten the mixing shaft using
a 22 AF open-ended spanner.
– Screw the mixing paddle (1) to the mixing
shaft (2).
Operation
Check to make sure the device is in a safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all device components are
correctly mounted.
Switching on and off
– Hold the device firmly with both hands.
– Dip the stirrer vertically into the substance to be
mixed.
– To start the tool turning, press the On/Off
switch (7) with the switch lock (6) held down and
hold them down.
– To switch the device off, release the On/Off
switch (7).
Electronic control of revolutions
The unit is fitted with an electronic revolution control
function.
The revolutions can be set to any level you require
(revolution range: Technical data – p. 22).
– When inserting into/removing from the sub-
stance, use low revolutions.
– When the stirrer is fully immersed, use the revo-
lution regulator (4) to set the required revolu-
tions.:
• Low number = Low revolutions
• High number = High revolutions
– During the mixing process, move the stirrer
around inside the container. Continue to mix until
all of the substance has been fully combined.
Cleaning
Cleaning overview
Prior to conducting any maintenance work
Regularly and according to the operating condi-
tions
Troubleshooting
What to do when something doesn’t work…
There are risks caused by spraying of the
substance you are mixing! Wear goggles.
When working with dusty substances, wear
a dust protection mask.
When machine parts rotate, do not wear
gloves.
DANGER! Risk of injury if switched on
accidentally! Pull out the power plug before
conducting any work on the device.
DANGER! Risk of injury! The device may
only be put into operation if there are no
defects. If a part is defective, it must be
replaced before the device is used again.
WARNING! Risk of injury! The unit may
only be used with the additional handle
mounted.
DANGER! Risk of injury! Wear goggles.
Do not reach into the operating stirrer.
Always start mixing with low revolutions.
NOTICE! Risk of damage to the unit! The
motor may overheat in the event of perma-
nent heavy loads and low revolutions. Run
the motor at higher revolutions in idle to
allow it to cool down.
DANGER! Risk of injury if switched on
accidentally! Pull out the power plug before
conducting any work on the device.
What? How?
Check the power cable
and plug for damage.
Conduct a visual inspec-
tion and have the cable
replaced by an electrician
if necessary.
What? How?
Clean the ventilation slots
of the motor to remove
dust.
Use a vacuum or a brush
to clean out the ventila-
tion slots.
Clean the device. Wipe the unit with a damp
cloth.
DANGER! Risk of injury! Unprofessional
repairs may mean that your device will no
longer operate safely. This endangers you
and your environment.
To Next Page
Loading...
General