Need help? c-m-p.com/support
TROUBLESHOOTING & FAQS
FREQUENTLY ASKED QUESTIONS
1. How do I install?
a. Use only a ¾” pipe or ¾” 90 elbow into the deck jet body (and make sure to use ABS to PVC glue).
b. The nozzles are designed to adjust to get a desired look with a reasonable amount of water going to the deck jet
(3 to 6 GPM). It is still necessary to use a valve in the line to control the amount of water going to the deck jet or
jets if multiple jets are used in a line.
2. How do I adjust the deck jet nozzle?
a. Use only the CMP deck jet nozzle wrench (25597-204-010) provided to install and remove the nozzle.
b. Turn the wrench slowly when adjusting (clockwise for more ow, counter-clockwise for less). The wrench can also
assist in adjusting the ow or the nozzle can be adjusted by hand.
c. When adjusting multiple deck jets, keep in mind the water has to go somewhere. For example, if there are three
deck jets and 2 have a ve feet high stream and one has a nine feet high stream, turning down the nine feet high
stream will make the other two more powerful. To make them all 5 feet high, the ball valve in the line would have
to be adjusted.
WATER SPECIFICATIONS
PER EACH JET
JET 1 JET 2 JET 3
GPM 3.0 5.0 7.0
FEET OF HEAD 3.9 7.9 11.9
HEIGHT OF JET 3.0 5.0 7.0
Covered by one or more U.S. patents or pending patent applications. See c-m-p.com/patents for details.
To Next Page
Loading...