CO/Tech 36-6706 - User Manual

GREAT BRITAIN • CUSTOMER SERVICE tel 020 8247 9300 e-mail customerservice@clasohlson.co.uk internet www.clasohlson.co.uk postal 10 – 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZ
Ver. 20170809
LED Under Cabinet Light
Art.no 36-6706, 36-6707
Please read theentire instruction manual before using theproduct
and then save it for future reference. We reserve theright for
any errors in text or images and any necessary changes made
to technicaldata. In theevent of technical problems or other
queries, please contact our Customer Services.
Safety
3. Press down on theconnector and disconnect thewires.
Placethelamp module to oneside.
6. Reassemble thelight fitting by first reconnecting thelamp
module to thehousing at theconnection which was
disconnected at step 3 above and then fitting thelamp
module back onto thehousing.
Care and maintenance
• Use adry cloth to wipe thelight fittingclean.
• Thelamps are non-replaceable. Nevertry to open
thelamp modules or modify thelight fitting in anyway.
Responsible disposal
The light source contained in this luminaire shall
only be replaced by the manufacturer or his service
agent or a similar qualified person. Caution to
the risk of electric shock during installation or
maintenance.
• This product must only be installed by aqualified electrician.
• This product is only intended for indoor hard-wired
installation.
• The operating temperature of the luminaire is −30 to 40 °C.
Installation
1. Warning: Before beginning any electrical
installation always disconnect thepower
to thecircuit you are working on, either by
turning off themain circuit breaker or by
removing thefuse from theconsumerunit.
2. Carefully pry thelamp module away from themain
housing of thelight fitting. Note: Makesure that thewires
connecting thelamp module and thehousing are not
damaged.
4. Pass thepower supply
cable through one of
thegrommets in thewall
of the housing. Becareful
not to damage thecable
entry grommet. Connect
thepower supply cable to
theterminalblock.
5. Screw thehousing onto themounting surface. Itcan be
mounted flat on asingle surface or angled between two
surfaces at right angles to eachother. Usetheincluded
screws and plugs or another appropriate fastening method.
36-6706
36-6707
This symbol indicates that this product should not
be disposed of with general householdwaste.
Thisapplies throughout theentire EU. Inorder to
prevent any harm to theenvironment or health
hazards caused by incorrect waste disposal,
theproduct must be handed in for recycling so
that thematerial can be disposed of in arespon-
sible manner. Whenrecycling your product, take it
to your local collection facility or contact theplace
of purchase. Theywill ensure that theproduct is
disposed of in anenvironmentally sound manner.
Specifications
36-6706
Rated voltage 220–240V
AC, 50/60Hz
Power 3.5W
Length 457mm
IP rating
36-6707
Rated voltage 220–240V
AC, 50/60Hz
Power 9.5W
Length 718mm
IP rating
Only intended for indooruse.

CO/Tech 36-6706 Specifications