To Next Page

To Previous Page

ENGLISH

Synchronisation

1. Place theunits close to eachother.

2. Make sure that thechannel selector (26) is set to channel 1.

3. Synchronisation will begin automatically once all batteries are inplace.

4. Theweather station will automatically display readings from channel 1 (if CH 1

does not show (3), press [ CH/▲ ] repeatedly until CH 1 shows).

5. If theoutdoor temperature shows (readings from thesensor) on theweather

station’s display, synchronisation is complete.

6. Theunits can now be placed at their desired locations. Note: Maxrange: 30m.

Adding additional sensors using channels 2 and 3

Theweather station can be supplemented by theaddition of two extra sensors

(soldseparately). Makesure that each sensor is assigned its own channel.

1. Choose asensor that you wish to broadcast on channel 2 and open its battery

compartment.

2. Set thechannel selector (26) to channel 2.

3. Observe themarkings on thebottom of thebattery compartment and insert

2×AA/LR6 batteries.

4. Reﬁt thebatterycover.

5. Press and hold in [ CH/▲ ] until thesignal icon (4) begins toﬂash.

Theweather station will begin searching for theoutdoor sensor.

6. Press [ CH/▲ ] repeatedly on theweather station until CH 2 appears (3).

7. After ashort moment, thereadings from channel 2 will appear on theweather station.

8. Repeat thesame procedure for setting another sensor to channel 3, if needed.

Placement/mounting

Weather station

• Theweather station has integrated temperature and moisture sensors. Becareful

when placing theunit so that it is not located near heaters, cookers, or other heat

sources.

• Theweather station can be used with its table stand (23) or hung on awall using

its eyelet (22).

• Avoid placing theunit next to metal objects such as metal window frames as this

may cause interference with reception.

Sensorunit

• Place thesensor in alocation that is protected from direct sunlight andrain.

• Mount thesensor at least 2.5 m above ground, if possible.

• Fasten ascrew to thewall and hang up thesensor from its eyelet (25).

CO/Tech E0201ST2H2 Manual

Other manuals for CO/Tech E0201ST2H2