INSTALL_OPS
MANUAL AMENDMENT
Manual: 251-16-1 Amendment #: 2
Document #: 251-16-1 809-0002 Amendment Date: Aug 9, 2011
Amendment # 2 August 9, 2011 Page 1
ENG-FORM: 809-0109.DOT
CONFIDENTIAL AND PROPRIETARY TO COBHAM
The purpose of this amendment is to update the 251 outline drawing and MOD table
per ECR11040.
Amendment Instructions:
Remove Pages Replace With Pages
1
Title Page Amendment # 1 Title Page Amendment # 2
Page ii Amendment # 1 Page ii Amendment # 2
Page iii Amendment # 1 Page iii Amendment # 2
Page b Amendment #1 Page b Amendment #2
Page c Amendment #1 Page c Amendment #2
Page d Amendment #1 Page d Amendment #2
2
Remove Drawings Replace With Drawings
251 Rev 1.51 (page 7) 251 Rev 1.70 (page 7)
2
Add Drawings After Drawings
251-003 810-0 Rev 1.30 Page 15
251-006 810-0 Rev 1.00 251-003 810-0 Rev 1.30
Note: Ensure that all drawings are inserted in the order shown on the latest drawing lists.
2 Update the Amendment Record sheet at the front of the manual.
3 Insert this page into the manual after the Amendment Record sheet (page iii).
Manual Amendment ends after the following amended pages
To Next Page
Loading...
General