C148CTL DX ALIGNMENT PROCEDURE
STEP
PRESET ТО
ADJUSTMENT
REMARKS
6
Same as Step 1.
VR4 for AM/FM
VR3 for SSB/CW
Set the SG to 40CH, 27.405MHz, 30% AM
modulation with lOOOuV. Then t u m the
VR4, so that the AF signal will appear
on Oscilloscope. Repeat it for SSB/CW
Mode with VR3.
7
Same as Step 1.
VR1 for AM/FM
VR2 for SSB/CW
Set the SG to 40CH, 27.405MHz with No
modulation. Level of SG is lOOuV. Then
adjust VRl for S-9 reading on radio's
meter for AM mode. Repeat it for
SSB/CW mode with VR2.
8
Same as Step 1,
Mode : Ш
L6
Set the SG tl lrnv with 1.5kHz déviation
of 1kHz. Adjust Lb for Max. signwave
output on Oscilloscope.
To Next Page
Loading...
