Cobra 148GTL-DX - Cobra 148 GTL-DX Installation Guide; Location and Mounting Procedures

LOCATION
Plan the location of the transceiver and microphone bracket before starting
the installation. Select a location that is convenient for operation and does not
interfère with the driver or passengers in the vehicle. In automobiles, the trans
ceiver is usually mounted below the dash panel, with the microphone bracket
beside it.
Section III
Installation
MOUNTING THE CONNECTION
The COBRA 148GTL-DX is supplied with a universal mounting bracket.
When mounting the bracket and radio to your car, make sure it is mechanically
strong. Also provide a good electrical connection to the chassis of the vehicle.
Proceed as follows to mount the transceiver:
__ . ........ ..
1. After y ou. hâve determined the most convenient location in your vehicle, hold
the COBRA 148GTL-DX with mounting bracket irt the exact location de-
■ sired. If nothing will interfère with mounting it in the desired position,
remove the mounting bolts. Before drilling the.holes, make sure nothing will
interfère with the installation of the mounting bolts.
2. Connect the antenna cable plug to the standard réceptacle on the rear panel.
, Most CB antennas are terminated with a type PL-259 plug and mate with the
réceptacle.
3. Connect the red DC power input wire (with the fuse) to +13.8V DC. This
wire éxtends from the rear panel. In automobile installation, +13.8V DC is
usually obtained from the accessory contact on the ignition switch. This
prevents the set being left on accidentally when the driver leaves the car and
also permits operating the unit without the engine running. Locate the ac
cessory contact on most ignition switches by tracing-the power wire from the
AM broadeast receiver in the car.
4. Connect the black lead to -13.8V DC. This is usually the chassis of the car.
Any convenient location with good electrical contact (remove paint) may be
used.
5. Mount the microphone bracket on the right side of the transceiver or near the
transceiver, using two screws supplied. When mounting in an automobile,
place the bracket under the dash so the microphone is readily accessible.