REMOVAL AND REPLACEMENT FRONT BRAKE PADS
1. Withdraw split pins on both pad retaining shafts.
2. Withdraw both pad retaining shafts. These are withdrawn and
replaced from the inside of both calipers.
3. It will now be possible to withdraw both pads complete with metal
backing plates.
(
REMOVAL AND REPLACEMENT REAR BRAKE PADS
1. Withdraw split pins on both pad retaining shafts.
2. Withdraw both retaining shafts.
3. It will now be possible to withdraw both brake pads complete with
metal backing plates.
HAND BRAKE REPLACEMENT BRAKE PADS
1. Hold back spring tensioner and remove rubber dust cap from brake
adjuster.
2. Remove split pin on pull rod pivot pin.
3. Tap out pivot pin;
4. Pull apart clamping levers and push down brake pull rod to permit
easy withdrawl of brake pads.
5. The pads are both held by retaining springs which must be released
before pads may bewithdrawn.
6. It should now be possible to remove brake pads and backing plates
from the socket provided without difficulty.
Note: When replacing rear brake pads the car must bejacked up and
the road wheelsremoved.
When ordering newfront or rear brake pads quote brakepart number.
(
31
To Next Page
Loading...