ADJUSTMENT
Remove the horn cover after withdrawing the fixing screw and
detach the cover securing bracket by springing it from its fixing.
Slacken the locknut on the fixed contact and rotate the adjusting
screw until the contacts are just separated (indicated by horn failing to
sound). Turn the adjustment nut half a turn in the opposite direction
and secure in this position by tightening the lock nut. Finally if the note
is still unsatisfactory, do not dismantle the horn but return it to a Lucas
Service Depot or Service Agent for examination.
(
THE IGNITION SWITCH AND
WARNING LIGHT
The ignition switch, besides forming a means of stopping the engine,
is provided for the purpose of preventing the battery being discharged
by the current flowing through the coil windings when the engine is
stopped. A warning lamp is provided which gives a red light when the
ignition is switched on and the car is running very slowly or is stationary,
thus reminding the driver to switch off.
Should the warning lamp burn out, this will not in any way affect
the ignition system, but it should be replaced as soon as possible in order
to safeguard the battery.
DASHBOARD BULBS
Ignition Warning Lights
2t
volt - 3 watts.
High Beam Warning Light
12 volt - 2·2 watt.
Direction Indicators Warning Lights
12 volt 2·2 watt Phillips.
(
Speedometer and Revolution Counter
12 volt 2·2 watt Phillips.
Electric Clock
Phillips 12 volt 2 watt 12829.
Panel Light Bulbs (Two)
12 volt 3 watt MCC P53 B 643 Torpedo Type Bulb.
44
To Next Page
Loading...