SALISBURY DIFFERENTIAL
UNIT 4HU
REMOVING THE
COBRA DIFFERENTIAL ASSEMBLY COMPLETE
The differential casing is supported on three rubber mountings. Two
of these are hanger bearings and are located on either side of the differential
casing, the front bearing is mounted on the nose of.the differential.
Unbolt the drive shaft flanges to the road wheels and the rear flange
on the propeller shaft. Remove the front mounting bolts, and support (
the weight of the differential with a jack or block.
Remove the two side hanger mountings, it may be necessary to rotate
the differential assembly when withdrawing the unit from the chassis.
DIFFERENTIAL MOUNTING
PART NUMBERS
FRONT SUPPORT CASTING C-66091
Metalistic Mounting 13/1121 D-63784
Distance Piece D-66202
Washer Internal Shake Proof
f'
~" B.S.F. Bolts 2i" long (Hex.)
,'0"
U.N.C. Bolts 1
i"
long D-66198
Support packing D-66196
SIDE SUPPORT CASTINGS
Metalistic Mounting
D-66534
13/860 D-63503
D-63503
Support Bolt with Self Locking Nut
i
B.S.F. 7" D-66208
,{" U.N.C. Bolts
11"
long D-66199
4
(1)
(2)
(1)
(2)
(2)
(4)
(4)
(2)
(4)
(2)
(4)
(
)
To Next Page
Loading...
General