4.
.
STARTING continued :
● Turn the lever clockwise to switch to the
“STARTING” position.
NOTE
○ If the throttle lever is squeezed or locked
at half position, the engine won’t start. Be
sure the throttle lever is in the fully CLOSED
position.
NOTE
○ When the engine is already warm up, no lift
up lever or choke lever required.
Recoil starter grip
● Pull the recoil starter grip slowly to engage
the starter, then give a short, quick pull.
WARNING
Releasing the starting rope suddenly
may allow the rope to whip around and
cause injury and/or damage the recoil
starting mechanism. When starting the
engine, fi rmly grasp the recoil starter
grip; do not grasp the starter rope itself.
Always control the rope as it rewinds
into the housing.
Throttle lever
Lift up lever
● Squeeze the throttle lever to switch the lift up
lever to the “RUNNING” (engine idle speed)
position, and then release the throttle lever
back to fully “CLOSED” (engine idle speed)
To Next Page
Loading...