Cobra Bridge 4100 - Factory Set up

Fitting instructions - BRIDGE 4100
28
PAGE 6
Slow flashing
Quick flashing
PAGE 7
FACTORY SET-UP
ACTIVED DISACTIVE
ACTIVED DISACTIVE
ACTIVED DISACTIVE
ACTIVED
DISACTIVEACTIVED
ACTIVED
DISACTIVE
ACTIVED DISACTIVE
ACTIVED DISACTIVE
ACTIVED
DISACTIVE
ACTIVED DISACTIVE
ACTIVED
DISACTIVE
ACTIVED
DISACTIVE
ACTIVED
DISACTIVE
DISACTIVE
1. GARAGE FUNCTION
4. ALTERNATING MONOTONAL SIREN
6. SIREN ACTIVATION ON SERIAL LINK
ò
2. LONG BLINKER ACTIVATION AFTER SIREN
3. NOT AVAILABLE
5. NOT AVAILABLE
8. NOT AVAILABLE
ADVANCED FUNCTIONS TABLE
7. TYPE OF ACOUSTIC SIGNALLING DEVICE (ALTERNATE HORN) ò
8. TYPE OF ACOUSTIC SIGNALLING DEVICE (SPEAKER) ò
ò
FUNCYIONS 6, 7 AND 8 WILL BE FACTORY-ACTIVATED ON THE BASIS OF THE ACOUSTIC
SIGNALLING DEVICE PRESENT IN THE KIT.
1. SIREN ACTIVATION VIA COBRA BUS
2. ULTRASONIC ACTIVATION VIACOBRA BUS
3. ENGINE IMMOBILISER ACTIVATION 1 VIACOBRA BUS
4. ENGINE IMMOBILISER ACTIVATION 2 VIA COBRA BUS
5. MODULE ACTIVATION ICD 30
6. PAGER ACTIVATION VIA COBRA BUS
7. KEYPAD ACTIVATION VIA COBRA BUS
THE MODULES MUST BE DISCONNECTED FROM THE COBRA BUS, BECAUSE THE COBRA BUS
AUTOMATICALLY SELF-ACQUIRES ANY CONNECTED ACCESSORIES (see modules/siren 4310
matching procedure)
THE INFORMATION GIVEN IN TABLE AT "PAGE 7" CAN BE CHANGED ONLY IN THE CASE OF
MALFUNCTION OF AN ACCESSORY CONNECTED TO THE COBRA BUS, AND THUS IT CAN
BE DISABLED (see modules/siren 4310 matching procedure..)
06DE2143E.pmd 07/02/2008, 15.1528