Cobra CXT1095 FLT - Mode Functions - Confirmation and Scan; Roger Beep and Key Tone Settings; Channel Scan Operation

14
15
Nothing Comes Close to a Cobra
®
Channel Scan
•
Your microTALK
®
radio can automatically scan channels.
To scan channels:
1. Press and release the Scan button until the Scan
icon and the channel numbers appear
on the display.
2. Press and hold the Scan button to begin scanning
channels.
The radio ignores specific privacy
codes while scanning channels.
The Scan icon will continue to be displayed when
scan is on. Your radio will continue to scan all
channels and stop if an incoming transmission is
detected. Your radio will remain on that channel for
10 seconds.
During scanning (while receiving an incoming transmission),
you can choose from the following:
a. Press and hold the Talk button to communicate on that channel.
Your radio will remain on that channel and return to Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning channels.
c. Press and hold the Scan button to return to Standby.
R
X
Vox
HI MED LO WX
TW DCS Scan
CTCSS Mem
BURP Power Saver
Scan Channels
Roger Beep Confirmation Tone
•
Your listener will hear an audible tone when you release the Talk button.
This alerts the other party that you are finished talking and it is OK for
them to speak.
To turn roger beep on or off:
1. Press the Mode/Power button until the
Roger Beep icon flashes. The current
on or off setting is displayed.
2. Press the Channel Up or Channel Down button
to select roger beep on or off.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
new setting and proceed to other functions.
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
R
X
Vox
HI MED LO WX
TW DCS Scan
CTCSS Mem
BURP Power Saver
Roger Beep Off
Key Tone On/Off
•
When Key Tone is On, an audible tone will sound each time a button
is pressed.
To turn key tone on or off:
1. Current key tone status On/Off will flash.
2. Press the Channel Up or Channel Down button
to select key tone on or off.
3. Choose one of the following:
a. Press the Mode/Power button to enter the
new setting and proceed to other functions.
b. Press Talk or Call/Lock button to enter the
new setting and return to Standby mode.
c. Do not press any buttons for 15 seconds to enter
the new setting and return to Standby mode.
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Channel Button
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Channel Button
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Channel Button
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Mode/Power
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Mode/Power
MEM
ESC
TRI
WATCH
SCAN
VOLUME
CALL
MODE
CHANNEL
H-M-L
Scan Button
Operation
Mode Functions
Operation
Customer Assistance WarrantyIntroduction
CXT1095_FLT_MANL.indd 14-15 12/20/13 2:40 PM