15
3.6 MOUNTING REAR BAFFLE PLATE COMPONENT
1.
Mounting the Pull lever (a) crossing the hole (b);
(see Figure m)
2.
Mounting the rear baffle plate component on the frame
using screws 1 (screw 5/16-18);
3.
Mounting the rear baffle plate component on the bracket
L&R using bolts 2 (M8-20);
3.7 MOUNTING GRASS-CATCHER
1. Mounting the front bracket 2 on the Top frame 3 using four screws 1 (M6-35);
2. Mounting the side stay pipe 5 on the Top frame 3 and front bracket 2 using four screws 1 (M6-35);
3. Mounting the grass bag on the frame component;
4. Mounting the cover (b)on the frame component using four screws (h) ST 5.5x35 and two screws (g) ST
5.5x16;
5. Put the overturn lever (a) into the grass-catcher cover board and insert the nut (e) and the bolt (d).
To Next Page
Loading...