18
– The «CHOKE» position enriches the mixture so must only be used if necessary when starting from cold.
– When moving from one area to another, put the lever in a position between «SLOW» and «FAST».
– When cutting, shift into «FAST»
4.2 STEERING WHEEL
Turns the front wheels
4.3 BLADE START/STOP KNOB
The blade start/stop knob is located on the RH console in front of the key switch.
The blade start/stop knob operates the electric clutch. Pull the knob upward to
engage the blades, or push the knob downward to disengage the blades.
4.4 KEY IGNITION SWITCH
This key operated control has four positions:
«OFF» everything is switched off.
«ON» activates all parts
«START» connects the starter Motor.
If you release the key on «START», it will automatically return to «ON».
This selection sends power to the head lights when the switch is in this position.
4.5 Brake Pedal
The brake pedal is located on the left front side of the board. The brake pedal can be
used for sudden stops or setting the parking brake.
When the machine is moving, keep your foot off the pedal.
4.6 PARKING BRAKE LEVER
With the machine stopped
：
1)
Keep the brake pedal pressed
；
2)
Lift the parking brake lever and keep lifted
；
3)
Release the brake pedal.
This way, the rear wheels remain braked. To release
the parking brake, fully press the brake pedal (the
parking brake lever is automatically released and returns to down position).
The engine can only be started at the parking position.
To Next Page
Loading...