23
Gradually release the brake pedal to engage the clutch and then begin moving in reverse.
When the machine is stopped, start the reverse movement by pressing the drive engagement pedal in the «R»
direction. (for hydro transmission model)
5.4.5 Grass cutting
To start cutting:
– move the throttle to «FAST»;
– raise the cutting deck as high as possible;
– engage the blades;
– start moving forwards on the grass very slowly and with utmost caution, as already described;
– regulate the cutting height and speed considering the conditions of the lawn. (The height, density and
dampness of the grass).
When cutting on sloping ground, reduce your speed to ensure safe operation.
Whatever the conditions, always reduce the speed if you notice a drop in engine speed. – if you travel too fast
compared to the amount of grass being cut, you will not be able to mow the grass as well.
Disengage the blades and raise the cutting deck as high as possible whenever you need to get past an obstacle.
This tractor will stop the blades when reverse is selected.
Press the override button (left of the steering wheel) to keep the blades rotating. Apply additional attention
when mowing in reverse, ensure it is safe to do so.
STOP THE ENGINE. WAIT FOR BLADES TO STOP. WHEN MAINTAINING/CLEARING THE TRACTOR
5.4.6 End of mowing
When you have finished mowing, disengage the blades, lower the engine speed and ride the machine with the
cutting deck raised as high as possible.
5.4.7 End of work
Stop the machine, move the throttle to «SLOW» and turn off the engine by turning the key to «OFF».
When the engine has stopped, close the fuel stopcock.
To avoid backfire, position the throttle on «SLOW» for 20 seconds before stopping the
engine
Always take out the ignition key before leaving the machine unattended
Never leave the key in the «ON» position. The battery will run flat.
5.4.8 Cleaning the machine
After use, clean the outside of the machine, empty the grass-catcher or discharge guard, and shake it to remove grass
and other debris. Clean the plastic parts of the body with a damp sponge using water and detergent, taking care not to
wet the engine, the electrical parts or the electronic circuit board located under the dashboard.
Never use hose nozzles or harsh detergents to clean the bodywork or the engine!
When washing the inside of the cutting deck and the collector channel, the machine must be
on firm ground with:
– the grass-catcher or discharge guard fitted;
– the operator seated;
– the engine running;
– the transmission in neutral;
To Next Page
Loading...
