37
Nothing Comes Close to a Cobra
®
VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your RadioVHF Marine Radio Protocols
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
Operating Your Radio
36
English
Using Rewind-Say-Again
®
to Record VOICE Audio
Transmission:
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
NOTE
If the record memory is locked (rewind icon ashing),
press and hold the REW button to unlock.
1. Press and hold SCAN button for two (2) seconds to enter
Record mode. The matrix will display MIC RECORDER.
2. Press and hold PTT button to begin recording
from radio microphone. The transmitter will turn off. The
matrix will display MIC RECORDER ON and the seconds
remaining will be shown in the lower right corner. If PTT
button is released, recording stops. While recording,
a 20-second countdown begins on display. When
20-second countdown time has ended, recording stops
and two (2) beep tones will be heard.
3. Press and hold SCAN button again for two (2) seconds or
press MEM/ESC button to cancel recording and return to
last operation.
Mobile Phone Operation
With Bluetooth
®
NOTE
Please refer to the Bluetooth Mode Pairing and Programming section on page 28 for
instructions on how to pair your mobile phone with this device. The following section
covers how to complete a phone call and other basic operations.
Answer Incoming Phone Calls
Mobile Phone Operation with Bluetooth
®
This handheld radio, once properly paired and connected to
your Bluetooth
®
compatible mobile phone, can answer incoming
calls received on your mobile phone. It can act as the speaker and
microphone, while your mobile phone stays safe and dry. It will also
improve audio quality on both ends of the conversation.
To Answer and End an Incoming Call:
1. The speaker will ring. The screen will display ANSWER/
DECINE and the caller ID, if available.
2. Press and release the ENTER soft key to answer the
call. After the call is answered, the screen will display
ACTIVE CALL.
3. Begin conversation with the caller by a pressing the
PTT (Push to Talk) key and speaking into the small
microphone above the LCD. This is very similar to a
standard radio operation and it completely eliminates
all background noise when you are not speaking.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
NOTE
To enable hands-free conversation or “VOX” mode
(pressing in the PTT key not required), see the Bluetooth
setup instructions on pages 27-28.
4. To end a call, press and release the END soft key. The
radio will then return to previous Standby mode and
resume normal operation.
Mobile Phone Operation
With Bluetooth
®
Initiate a Phone Call
There are several ways to initiate a call. These include initiating
(as normal) from the mobile phone, using voice dialing and last
number redial.
To Initiate from the Mobile Phone
1. Simply dial a number on your mobile phone.
(See manufacturer’s instructions for making a call.)
When the phone’s Send key is pressed, the radio will
respond by changing over to Bluetooth mode and the
matrix will display ACTIVE CALL and the option to END.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Caution Warning
Installation
Customer
Assistance
INCOMING CALL
CALL FROM
Bill Smith
ANSWER
DECLINE
EXIT ENTER
ACTIVE CALL
END CALL
END
MRHH600EU_ENG_MANL.indd 36-37 4/4/17 2:55 PM
To Next Page
Loading...
