Customer Assistance WarrantyIntroduction Operation
10
Mode Functions
Operation
11
Set DCS Privacy Codes
•
To select a DCS privacy code:
1. After selecting a channel, press the Mode
button until the DCS icon appears and the small
numbers flash on the display
(01 through 104).
NOTE
If CTCSS is turned on at the channel
selected, the display will flash the
DCS icon and “OFF.” To switch from
CTCSS to DCS, press the Channel Up
or Channel Down button while the display
is flashing “OFF.” The display
will then show the small numbers flashing
and you will then be able
to proceed to step 2.
2. Press using the Channel Up or Channel Down
button to select a DCS privacy code. You can hold
the Channel Up or Channel Down button for fast
advance.
3. When your desired DCS privacy code is displayed,
choose one of the following:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock/Enter button to enter the new
setting and return to Standby mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to Standby
mode.
NOAA* All Hazards Radio Channels
•
You can use your microTALK radio to listen to NOAA All Hazards Radio
channels transmitting in your area.
To listen to All Hazards Radio channels:
1. Press the Mode button until the WX (All Hazards
Radio) icon, the currently selected All Hazards
Radio channel, and signal strength are displayed.
2. Use the Channel Up or Channel Down button to
change All Hazards Radio channels.
3. WX (All Hazards Radio) icon will continue to be
displayed when All Hazards Radio is on. Choose
one of the following:
a. Press the Mode button to proceed
to other functions.
b. Press the Lock/Enter button to exit All
Hazards Radio channels mode and return to
Standby mode.
*National Oceanographic and Atmospheric Adminstration
Mode Button
Channel Buttons
DCS Privacy Code
Mode Button
Channel Buttons
Hazards Radio Icon
To Next Page
Loading...
Need help?
General
