Cobra MPC COBRA SERIES - Installing the Cobra - Step 1-3; Install Strike Components; Install Cylindrical Latch

COBRA INSTALLATION AND PROGRAMMING GUIDE
Installing the Cobra
57010-H Page 4 12-19-2005
Installing the Cobra
Installing the Cobra
1) Install the Strike Components into the Door Frame:
2) Install the Cylindrical Latch:
3) Change Handing if Necessary:
• Insert str
ik
e
b
ox
(
a
)
i
nto
d
oor
f
rame.
• Place strike (b) over strike box.
• Secure in place with 2 screws.
b
a
• Insert t
h
e cy
li
n
d
r
i
ca
l
l
atc
h
i
nto t
h
e e
d
ge o
f
t
h
e
d
oor.
NOTE: Sloped side of latch (a) should face door strike.
• Secure in place with 2 screws.
a
b
a
O
uts
id
e escutc
h
eon
i
s s
h
own
i
n
fi
gure.
• Remove and retain 5/32” socket cap screw (a).
• Remove lever.
• Rotate lever (b) to opposite position.
• Apply thread lock compound * to screw.
• Reinstall screw.
• Repeat for inside escutcheon (not shown).
• * Loctite 242 is recomended.