Cobra SPX 7700 - Mounting the Detector; Suction Cup Mounting

Mounting
Your detector should be mounted on the windshield or dashboard of
your vehicle. Two mounting options are included:
Suction Cup Mount -
This is the best option for portability and mov-
ing the detector from car to car. Make sure to
thoroughly clean the suction cups and wind-
shield mounting area to insure a tight seal.
Hook and Loop Fastener-
Included for dashboard mounting.
Suction Cup Mount
Hook
& Loop Fastener
Your detector should be mounted so that it is oriented
parallel to the road .
Correct Position
Incorrect Positions
The suction cup mount comes standard bent at
a 45 ° angle. The metal is designed to bend
without breaking. Adjust the angle so when
mounted the detector is level with the road.
Avoid blocking the detector's view by windshield wiper
blades or dark tinting at the top of the windshield .
Note: Do not attempt to bend the mount while the detector
is attached.