Settings and Detection
Your Detector
Nothing Comes Close to a Cobra
®
15
Settings
Your Detector
14
English
Detection
The tables on the following pages show you the types of Signals your detector
will detect, as well as the voice and visual alerts it provides for each of them.
In Voice Alert mode you will first hear several tones, then a voice message
announcing the type of signal detected, followed by more tones. In Tone Alert
mode, you will hear the tones only.
In both Voice Alert and Tone Alert modes, a distinctly different alert tone is used
for each type of signal detected (including separate tones for each laser signal).
For X, K, Ka and Ku band radar signals, the tones will repeat faster as
you approach the signal source. The repeat rate of the tones gives you useful
information about the signal detected. (See responding to alerts on page 18.)
An indication of the type of signal detected will appear in the UltraBright
data Display. During X, K, Ka and Ku alerts, a number will also appear,
indicating the strength of the signal detected. (1 = weakest, 5 = strongest)
X Signal Detected
X K Ka V S 2
X K Ka V S 3 X K Ka V S 5 X K Ka V S 4
K Signal Detected Ka Signal Detected
Ku Signal Detected
To Turn Pop Alert On and Off
While no signal is
being detected,
press and hold both
the Dim and City
buttons for four
seconds.
Tone Voice
Visual Display
Pop On = Two beeps
Pop On
P will blink twice
in the display
Pop Off
P will blink once
in the display
Pop Off = One beep
Radar Alert Settings
The detector allows you to choose whether it will show alerts on the X, K
and Ku bands. The factory settings are: X Band and K Band On; Ku Band Off.
To Turn K Band On and Off
While no signal is
being detected,
press and hold both
the Mute and City
buttons for four
seconds.
Tone Voice
Visual Display
K On = Two beeps
K On
K will blink twice
in the display
To Turn Ku Band* On and Off
While no signal is being
detected, press and
hold the City button
for four seconds.
Tone Voice
Visual Display
Ku On = Two beeps Ku On
X and K will blink
twice in the display
K will blink once
in the display
K Off = One beep
K Off
Ku Off
X and K will blink
once in the display
Ku Off = One beep
To Turn X Band On and Off
While no signal is
being detected, press
and hold both the Dim
and Mute buttons for
four seconds.
Tone Voice
Visual Display
X On = Two beeps
X On
X will blink twice
in the display
X Off
X will blink once
in the display
X Off = One beep
Pop Alert
The Pop Mode Radar Gun is a single-pulse Doppler radar that is a feature
of a K and Ka (Bee III Ka radar gun) band Instant-On radar gun. It uses
a single, short-time pulse to measure the target vehicle’s speed.
The Pop mode receiver senses Pop singles beyond the effective range of Pop
radar guns. As the Pop mode receiver is so sensitive, you should limit the use
of Pop Detect mode to highway and rural driving.
Pop Alert will alert you to Pop radar signals. During the alert, the unit
continues to detect other signals. The factory setting is Pop Detect Off.
Pop Alert (continued)
To Turn Safety Alert On and Off
While no signal
is being detected,
press and hold
the Dim and iMute
buttons for
four seconds.
Tone
Voice
Visual Display
On = Two beeps Safety Alert On
S Flashes Two Times
Off = One beep
Safety Alert Off S Flashes One Time
SPX955_MANL.indd 14-15 4/10/15 2:05 PM
To Next Page
Loading...
Need help?
General
