Cobra SPYBALL 6808-9 - Page 39

___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 39
transmitter.
paragraph 15)
- Operate the transmitter closer to the unit (the area might be
affected by noises interfering with the radio signal)
- Replace the transmitter battery
- Realign the transmitters (see paragraph 2.1. )
- If none of these operations is successful, contact a Spyball
dealer (in the meantime, if the system is armed, disarm it with
the PIN code (see paragraph 16)
The alarm/immobiliser is disarmed, but
the motorcycle will not not start
(6828-9)
- Make sure the motorcycle is in neutral gear
- Make sure the kill switch is in the RUN position
- Make sure the main ignition fuse in the motorcycle is intact
- Make sure the motorcycle battery is charged
- Some models will only start with the side stand up or the clutch
lever pulled in  please check
- If none of these operations is successful, contact a Spyball
dealer
The system is not triggered by
moving/lifting the bike
- Has the inhibition time elapsed?
- Is the movement detector activated (not deselected)?
- If necessary, please adjust the movement detector (see
paragraph 7.)
- If none of these operations is successful, contact a Spyball
dealer