“Turn indicator on” audible
warning signal
Press push-button n. 1 of
the transmitter after the
third flash
Three (3) sharp audible
signals follow
Press push-button n. 2 of
the transmitter after the
third flash
One (1) sharp audible
signal follows
Press push-button n. 1 of
the transmitter after the
fourth flash
Three (3) sharp audible
signals follow
Press push-button n. 2 of
the transmitter after the
fourth flash
One (1) sharp audible
signal follows
Polarity of the
instantaneous alarm
trigger input (for dealer
use only)
Press push-button n. 1 of
the transmitter after the
fifth flash
Positive polarity
Press push-button n. 2 of
the transmitter after the
fifth flash
Negative polarity
Once the selections are finalised, a long low audible sound will confirm that they have been
entered successfully.
Note1): If you wish to modify any functions, you can reset them individually without needing to
reset all 5 functions.
Note 2): in the event of an error, turn ignition off to quit without making any changes.
Note 3): do not alter the polarity of the instantaneous alarm trigger input (5 flashes) as set up
by the installer, or this protection function will stop working.
Note 4): the audible on/off signals are illegal in some Countries. Please check your local
regulations and set up the system accordingly.
To Next Page
Loading...
