Cobra SPYBALL 6829 - Page 23

23
Spyball dealer (in the meantime, if the system is
armed, disarm it with the PIN code (see paragraph 16)
The alarm/immobiliser is
disarmed, but the motorcycle will
not start
- Make sure the motorcycle is in neutral gear
- Make sure the kill switch is in the RUN position
- Make sure the main ignition fuse in the motorcycle is
intact
- Make sure the motorcycle battery is charged
- Some models will only start with the side stand up or
the clutch lever pulled in – please check
- If none of these operations is successful, contact a
Spyball dealer
The system is not triggered by
moving/lifting the bike
- Has the inhibition time elapsed?
- Is the movement detector activated (not deselected)?
- If necessary, please adjust the movement detector
(see paragraph 7.)
- If none of these operations is successful, contact a
Spyball dealer
18.TECHNICAL DATA
Power supply (control unit)
Nom. 12V Max 17V Min. 9V
Current consumption rate
< 1 mA OFF; 1mA ON (including the LED)
Back-up battery
Rechargeable 7,2V 170mAh NiMH battery
Capacity of engine immobilisation circuit
Max 6A
Operating temperature
-20°C / +85°C