Cobra XRS 9670 - Setting IntelliMute Activation Point via Program Mode; Program Mode Procedure for Setting RPMs

Program/Mute Button @
•... @ Set/City
Button
@ Select/Dim
Button
Set IntelliMute
None
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set
IntelliMute.
Press and release the Set/City button
to begin setting IntelliMute RPMs.
Two beeps
Press SET at
desired RPMs ...
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
None None
At the desired rev level, press and
release the Set/City button.
Three beeps IntelliMute Set!
Press and release either the Select!
Dim button to proceed to the next user
mode or the Program!Mute button to
exit the Program mode.
None
None
Setting IntelliMute RPMs
(0) NOTE
If the unit is unable to sense usable pulses
within three seconds or if you do not set a
rev point within 20 seconds of beginning
these steps, IntelliMute will indicate an
error and automatically turn Off.
Set Intel. .. Press SET ...
One beep
One beep
IntelliMute not set
Please try again
IntelliMute Off
IntelliMute
Not Set
InlelliMu .
Please
Ir .
IntelliMute Off
I ntelli
Mute
Off
Nothing Comes Close 10 a Cobra- ~