Cobra XRS 9670 - Calibrating Compass via Program Mode; Program Mode Compass Calibration Steps

Tone Visual Display
None
•
~
~' Settin s
Program/Mute Button @
To Calibrate the Compass Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to
Set Compass.
•••. @ Set/City
Button
@ Select/Dim
Button
Set Compass
Press and release the Set/City button
to begin setting the compass.
Within two minutes, drive your
vehicle in a circle twice, then press
the Set/City button again.
Press and release either the Select/
Dim button to proceed to the next user
mode or the Program!Mute button
to exit Program mode.
One beep
Three beeps
None
Drive in 2 circles ...
Press SET when
done ...
Compass Set!
For two seconds
followed by direction
of travel (N, NE, E,
SE, S, SW, W or NW)
None
Set Compass Calibrate Compass Compass Set
Set Compa ...
(Ii) ~~~~ do not press the Sel/City button within two minutes after beginning
the set compass process, compass calibration will automatically terminate.
Compass not set. ..
Please try again ...
Terminate
Compass n ..
Please Ir ...