E4
E-1
-
CASSETTE TAPE RECORDING
PRESERVATION OF RECORDINGS
- OPEN THE CASSETTE DOOR BY PRESSING THE "STOP/EJECT"
CASSETTE BUTTON.
- INSERT A BLANK CASSETTE WITH THE TAPE-SIDE UP, INTO
THE PROPER GUIDE-RAILS ON THE INSIDE OF THE CASSETTE DOOR.
- GENTLY PUSH THE CASSETTE DOOR FORWARD (INWARDS) TO CLOSE
IT, MAKE SURE THE TAPE IS FULLY AND PROPERLY INSERTED BEFORE
DOING SO.
- THE SET IS NOW READY TO START RECORDING. WHICH CAN BE DONE
FROM EITHER LIVE SOURCE OR THE RADIO.
RECORDING FROM RADIO
- SLIDE THE FUNCTION SWITCH TO "RADIO" POSITION.
- TUNE IN THE DESIRED STATION BY TURNING THE TUNING KNOB
IF NECESSARY, EXTEND THE TELESCOPIC ANTENNA, AND ADJUST
POSITION OF THE SET TO IMPROVE RECEPTION.
- PRESS THE PLAY AND RECORD BUTTONS TOGETHER.
- DUE TO THE "ALO" FUNCTION (AUTOMATIC LEVEL CONTROL) NO
FURTHER ADJUSTMENTS ARE REQUIRED. THE VOLUME CONTROL
WILL NOT AFFECT THE RECORDING.
- TO PREVENT ACCIDENTAL ERASURE OF CASSETTES, SIMPLY BREAK OFF
THE TWO PLASTIC TABS LOCATED ON THE REAR EDGE OF THE
CASSETTE. WHEN A CASSETTE WITH REMOVED PLASTIC TABS IS
INSERTED, THE RECORDING BUTTON CANNOT BE DEPRESSED.
- IF A CASSETTE IS TO BE ERASED AND RE-RECORDED AT A LATER
STAGE, SIMPLY COVER THE HOLES ON THE CASSETTE WHERE
THE TABS WERE REMOVED, WITH A PIECE OF STRONG ADHESIVE TAPE.
SPECIFICATIONS
POWER SUPPLY: .................................... AC110V OR 220V 50/60Hz
DC6V = 4 X"D" (UM-1/R-20)SIZE
BATTERIES (NOT INCLUDED)
CX-144 AM/FM RADIO CASSETTE
PLAYER/RECORDER
OPERATING INSTRUCTIONS
COBY
To Next Page
Loading...