D. 1 x Changing Table
Assembly instructions:
Important: you have to fix up each 4 sides of the cot in order to be able to push
down the centre bottom button. If you do not fix the sides first, of the the sides
will drop down when pushing the button.
Unfold the mattress and place on the metal poles. The hard ply wood side
should be resting on the metal poles with quilted side up.
E. Change Table tubes
B. 1 x Mattress
C. 1 x Bassinet with 6 x interlocking poles
F. Travel/Storage Bag
G.Nursery Organiser
Contents Check List:
Check that you have all the parts for this model before assembling your co-
sleeper camp cot.
A. 1 x Camp Cot
H. Safety straps and anchor plate
1. Unzip the storage bag to unpack your co-sleeper. Remove all the contents.
2. Spread out the cot. Secure each side invidually by holding one hand on the
rail and the other on the hinged side bar (as shown in the image) and pull up
sharply to lock in one place.
3. All 4 sides need to be locked in place before you press down the centre floor
of the camp cot.
4. Zip in the bassinet making sure that the velcro tabs are on the same side as
the lowering bar. Ensure that bassinet safety hook is clipped into the frame.
5. Connect the metal poles in the base of the bassinet. Make sure you have
made a secure connection between the metal poles.
Converting your camp cot to the co-sleeping position: IMPORTANT!
Remove infant from this product before starting any conversions.
1. Release the velcro tabs on the inside of bassinet at either end of the lowering
side bar. Make sure the bassinet safety hook remains connected to the frame.
2. Find the lever on both sides of the lowering side bar. Squeeze the lever
upwards to unlock (as shown) then press down on the side bar to slide and
lower the bar down to the desired height.
3. There are 2 levels that the lowering bar can be dropped to. Choose the height
best suited to your bed. When lowering the side bar, make sure that the side bar
is NOT lower than the top of baby's mattress, ( this is important if you are using
a foam mattress inside your camp cot ).
4. Place your co-sleeper camp cot right up against your bed and secure in place
by attaching the safety anchor straps to either side of the camp cot , then feed
these straps under the adult mattress to the opposite side and hook onto the
adults mattress with the metal plate. Tighten straps for a snug fit. Finally ,
ensure that you lock the wheels of the camp cot for additional safety.
Your co-sleeper camp cot set up is now complete and it is now safe for you to
place your baby in the camp cot.
EN
To Next Page
Loading...