Cochlear
™
Wireless Phone Clip
Quick guide for Baha
®
users
Benefits of your Cochlear Wireless Phone Clip
Enjoy hands-free calling direct to your Baha 4 Sound Processor.
Hear your Bluetooth-enabled navigation system directly in your
Baha 4 Sound Processor.
Discreetly adjust your Baha 4 Sound Processor by using the
Phone Clip as a remote control.
Stream music from a Bluetooth-enabled device.
The Phone Clip can be easily attached to clothing. The built-in
microphone will pick up and transmit your voice, even if your phone
is several metres away.
Product overview Getting Started
Check with your hearing healthcare professional whether your sound processor has been
paired with your Phone Clip. Pre-paired sound processors do not need to be paired again.
If your sound processor is not pre-paired, instructions on how to easily pair it with your
Phone Clip are on the last page of this guide.
Tip! Make sure that your sound processor volume is comfortably adjusted before you change
the settings with the volume control on the Phone Clip.
Call pick-up/
hang-up button
Micro-USB connector
for charging
Sound processor
program button
Sound processor
microphone
mute button
Microphone
inlet
Volume
control
10-30cm between mouth
and Phone Clip
Charging the battery
Plug one end of the included micro-USB charging cable into the Phone Clip and the other
into a computer, or into a power outlet via the supplied adapter.
When the red LED indicator on top of the Phone Clip turns green with a red blink every 2
seconds charging is complete.
The first time you charge your Phone Clip allow it to charge for at least 3 hours, even if the
indicator light shows a full charge. The battery cannot be overcharged.
Note: The Phone Clip provides 6 hours of talk time or 80 hours of standby time from a full
charge.
ON/OFF
switch
OFF
ON
To Next Page
Loading...
