4.
3. Installation and starting.
1.1. Place the machine on a level and watertight
surface.
1.2. Connect to the Cold water supply using the hose
provided. The most appropriate connection is to
a tap that can be turned off.
The pressure shall be 14.5 – 72.5 PSI
(1 – 5 bar) for the automat to function
properly
Refer to Programming on page 9 when filling
the water manually.
1.3. Insert the power plug in a separately-earthed wall
socket. 230 V, 10 A.
1.4. Switch on using the switch that is located at the
back of the machine.
Check that the light comes on.
To Next Page
Loading...