Install the Wafer Reader
16
To Connect the Breakout Cable to the Wafer Reader:
1. Verify the 24VDC power supply being used is switched off.
2. Attach the Breakout Cable’s power (white-green wire) and ground (brown wire) to the
corresponding terminals on the power supply.
3. Connect the wires for the acquisition trigger, discrete outputs, and serial
communications to their corresponding terminals on remote devices.
4. Plug the RJ-45 connector into the wafer reader’s Breakout Port (labeled 24VDC).
5. Restore power to the 24V supply. The green power LED will indicate that the wafer
reader is receiving power.
To Next Page
Loading...
Need help?
General
