Step 3 : After emptying, replace the tank in the dehumidifier following the arrow
direction from bottom to top. Confirm the tank is installed in position and the
red Indicator light off.
• NOTE:
• Replace the empty tank back into the unit and once seated correctly, please
press power button, the unit will start up again.
• You should hear a click when the tank is in the correct position.
• Do not remove the float in the tank, otherwise, the sensor will not be able to
sense the water level properly, so that the water will overflow from the tank when
the tank is full.
Float
• Wipe the tank after every use clean with a damp cloth to prevent mildew.
• Be careful not to spill any of the dirty water as you dump it down a sink or outside.
• Do not drink or use the water drained from the dehumidifier.
To Next Page
Loading...