SET
UP
INSTRUCTIONS
!!! Very Important !!!
Before plugging it in, be sure the dispenser has been in an upright position for
twenty-four hours to allow the oil in the compressor to settle after shipping.
The dispenser is fully assembled - here's all you do:
1.
Place it: Take the dispenser
to
the location where it will be used. Ensure access to a
properly grounded 120 volt AC electrical outlet.
2. Plug it in: Plug one end
of
the power cord into the Power Module on the back
of
unit, the
other into the grounded 120 volt AC outlet. Maintain at least a minimum 3 inch clearance
from the filter on rear
of
machine.
3. Turn it on: Press the on-off switch on the Power Module on the back
of
the unit. Be sure
the power indicator light is lit.
4. Let
it
run: Run for
15
minutes
to
become fully chilled before loading the flrst bag
of
product.
5. Load
it:
See Optimum Bag descriptions below; see bag-loading instructions.
EXTENDED
SHELF
SHELF
STABLE
LIFE (ESL)
Proprietary Bag
Proprietary Bag
Be
su
re
bag
has
been
Be
su
re
bag
has
been
kept
stored
under
kept
chilled
to
under
80
degrees
F.
41
degrees
F.
These
bags
are
designed
witll
two
bottom
corners
sealed
off
for
easy
loading.
Tile
spout
is
near
the
bottom
of
the
bag.
3
To Next Page
Loading...