Colgate Blast 2 Series - Inserting and Removing Nozzles; Filling and Adjusting Water Flosser; Using the Water Flosser Effectively

Filling the Water Tank:
1. Open the water tank cover.
2. Lay the flosser flat, face the opening
towards the faucet and fill with cold/
lukewarm water or mouthwash.
You may use warm water up to 40C/104F.
3. After filling the tank with water, close the
cover firmly, and dry off any excess liquid.
Adjusting the Pressure Settings:
1. Device turns on in the last mode used.
2. Press the mode button to switch between
pressure settings for your preferred flossing style:
Gentle: Low pressure mode.
Regular: Standard pressure mode for daily cleaning.
Deep Clean: Strong pressure mode for deep cleaning.
Massage: pulsation pattern for gum massaging.
Spot Spray mode: Control the flow of water with the
touch of a button. If you have selected spot spray mode,
you can control the flow of water through the On/Off
button. Press and hold the On/Off button for water flow,
and let go to stop water flow.
3. The default mode for the water flosser is gentle,
it is recommended to start on the gentle mode
and gradually increase modes if desired.
Inserting and Removing Nozzles:
1. Remove the nozzle from the package.
2. Insert the nozzle into the nozzle jack
until it clicks into place.
3. To remove the nozzle, press and hold
the 'Smile' nozzle eject button and
gently pull out the nozzle.
Warning:
Do not eject the nozzle during operation.
Using the Water Flosser:
1. Place the nozzle into your mouth before turning the device on.
2. Align the nozzle against your teeth and gum line.
3. Work the nozzle along the gumline, paying special attention
to the area between teeth and around braces.
4. While flossing, open your mouth slightly to avoid water splashing.
5. Keep the flosser upright during use to prevent
the tube in the tank from restricting water flow.
6. T he water tank should allow for up to 60 seconds of flossing depending
on the mode. Refill water tank as needed to complete flossing session.
7. After pressing the off button, the water flosser will remain in standby mode
for 30 seconds. After 30 seconds in standby mode, the water flosser will
turn off. After 2 minutes of flossing, the water flosser will automatically
switch off.