Colugo Infant Kit - Connecting the Infant Kit; Step-by-Step Attachment

6 CONNECTING YOUR COLUGO INFANT KIT
STEP 1
Fully unbutton the base layer from
the frame. Lift the rear canopy rod
to disconnect the backrest from the
frame, then put the rod back. To fully
remove the canopy, see page 13.
STEP 2
Unhook the base
layer. Fold the sides
and rear mesh panel
onto the backrest.
STEP 3
First, slide the
canopy side over
the footrest.
Then slide the infant kit
footrest over the other side by
folding it up. Make sure all straps
are tucked under the infant kit.
STEP 4
Hook the side support
onto the frame.
STEP 5
Snap the canopy
into place.
STEP 6
Ensure the
closure straps are
secured to the
bottom with velcro.