Enhance your
XFINITY
®
TV
experience with the
Aim Anywhere™
Adapter!
Pair your adapter and XFINITY
Remote to get started.
Your XFINITY Remote can be paired
with the Aim Anywhere Adapter (also
known as the XR8) allowing you to
control your set-top box even when the
device is placed out of line-of-sight (for
example, in an entertainment center or
behind your TV). XFINITY Remotes can
be identied by an XR model number
on the back of the remote.
See the “Compatible Devices” section
on the back of this user guide to verify
that your set-top box and remote are
compatible with the adapter.
To pair your XFINITY Remote with the
Aim Anywhere Adapter, follow the steps
below.
HERE’S HOW:
1. Turn on your TV and set-top box.
2. Plug the Aim Anywhere Adapter into
the IR Input port* located on the
back panel of your set-top box.
*Note: This port may also be labeled
IR Input, IR Receive, or EXT IR IN.
3. Wait 3-5 seconds for the solid red
LED on top of the adapter to turn o.
4. Press and release the PAIR button
on the back of the adapter. The LED
It’s simple to pair your XFINITY Remote with
the Aim Anywhere Adapter.
XFINITY Remote
Aim Anywhere Adapter
USER’S GUIDE
XFINITY Remote
Aim Anywhere Adapter
USER’S GUIDE
on top of the adapter will turn on
when the PAIR button is pressed.
5. Press and hold the Setup button
on your XFINITY Remote until the
remote’s LED changes from red to
green. Then, press and release the
XFINITY button.
6. If the LED on the XFINITY Remote
blinks green twice, pairing was suc-
cessful. Press CH ^ to verify that your
set-top box responds as expected.
7. If the LED on your XFINITY Remote
blinks red, then green, and then red,
pairing was unsuccessful. Check
the “Compatible Devices” section to
verify that your set-top box supports
the Aim Anywhere Adapter.
xnity.com
©2013 Comcast Corporation. All rights reserved.
Xnity LED
(top)
XR8 logo
(bottom)
PAIR button
To Next Page
General