To Next PageTo Next Page
Need help?Do you have a question about the Comdel CPS-1001/S/13.56MHZ and is the answer not in the manual?
General| Brand | Comdel |
|---|---|
| Model | CPS-1001/S/13.56MHZ |
| Category | Power Supply |
| Language | English |
Explains symbols like CE mark, general warning, high voltage, short circuit, RF energy, and ground.
Details warnings about hazardous voltages, RF burns, proper grounding, and handling heavy objects.
Discusses applying safety and warning labels as required by local regulations.
Outlines requirements for CE marking, installation, insulation category, and circuit separation.
Explains the 24V safety interlock circuit for disabling the unit during faults.
Details procedures for locking out and tagging out the generator for maintenance.
Lists input voltage, current protection, output power, frequency, stability, and harmonic distortion.
Describes mismatch, interlock, over-temp, short-circuit, and overdrive protection features.
Details signal input impedance, isolation, line connections, RF output connector, and control signals.
Details size, mounting, cooling, front panel indicators, handles, color, and warning labels.
Specifies operating temperature, humidity, and air pressure requirements.
Outlines production acceptance testing procedures and final test reports.
Lists supplied accessories and notes on shipping and repairs.
Details the required 208 VAC three-phase input power and current draw.
Specifies required water flow rate, pressure, temperature, and ambient air.
Outlines installation compliance with directives and connector accessibility.
Step-by-step guide for operating the generator locally via the front panel.
Explains how to control power and monitor forward/reflected power remotely.
Lists required instruments and accessories for testing.
Describes the DC power section including transformer, rectifier, and low-pass filter.
Explains the crystal oscillator, buffering, amplification, and ALC circuitry.
Details the two-transistor "Class C" power amplifier stage and splitter.
Describes the eight power bipolar transistors in push-pull configuration.
Explains how it monitors and produces signals for forward and reflected power.
Identifies it as the main connection point for power supplies and circuits.
Details potentiometer adjustments on the meter board for OV/OC.
Explains adjustment of R1 on the OCB to limit power under high VSWR.
Details setting DC voltage output proportional to forward power.
Describes setting DC voltage output proportional to reflected power.
