EasyManua.ls Logo

Comet MTP MC 18 - Hydraulic Connections

Comet MTP MC 18
84 pages
Go to English
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
APPLICATIONS
WARNING
•Adequatelyprotectthemovingpartswithsuitableguards.
•emotorpumpmustoperatewithoutexceedingpressureandrotationspeedlimitsasshownontheidentication
plate(12).
epumpapplicationsmustbemadefollowinggoodmechanicalengineeringpractices.eManufacturer’s
Aer-SalesServiceisatthedisposalofthe
Skilled Technician
to provide all necessary information.
HYDRAULIC CONNECTION
WARNING
•esuctionandbypasspipesmusthaveaninternaldiameterequaltotheouterdiameterofthesuctionand
bypassttingsrespectively,andanominalpressureof10bar(145psi)and
mustnotbeaectedbyblockages
of any kind
.
•edeliverypipesmusthaveaninternaldiameterequaltotheouterdiameterofthedeliveryttingsanda
nominalpressurenotbelowmaxpumppressure.
•Allthepipesmustbermlyfastenedwithclampstotherespectivettings.
Forthehydraulicsuction,deliveryandbypassconnections,refertothefollowingtableandtoFig.12,which
represents a generic diagram of a possible machine integrating the motor pump.
1. Tank
2. Suction lter
3. Suction circuit
4. Pump
5. Delivery circuit
6. Bypass circuit
7. Spray nozzle (example of accessory)
8. Engine
CAUTION
•Followtheconnectioninstructionsalreadyindicatedinthe
checkIng and connectIng up to the water
supply
and
“specIfIcatIons and technIcal data
paragraphs.
Inparticular,thesuctioncircuitmustbesizedsoasnottodetermineonthemotorpumpsuctiontting:
-apressurehigherthan0.1bar/1.45psi(8bar/116psiforMTPYA65);
-avacuumhigherthan0.25bar/3.63psi(0.3bar/4.35psiforMTPYA65).
ExceptfortheMTPMC8,MTPMC18,MTPMC20/20andMTPMC25,suctionvacuumsuptomax
0.45bar/6.53psi(0.5bar/7.25psi)areonlyacceptableforoperatingperiodsof10÷15minutes.
•Atmotorpumpsuction,alterofadequatedimensionsmustbetted.Incaseofdoubts,contactthe
Manufacturer.
•Donotsupplythemotorpumpwithliquidsatatemperatureabove40°C/104°F (60°C/140°Ffor
MTPYA65)orbelow5°C/41°F.
EN

Related product manuals