7
Lubrication
All moving parts in the winch are permanently lubricated at the time of assembly. Under normal
conditions factory lubrication will suffice. If re-lubrication is necessary after repair or disassembly
use a marine type grease.
Maintenance Schedule
Carry out all inspections listed below on schedule and inspections are divided into Daily, Monthly
and 3 Monthly. Clean all connections because corrosion on electrical connections will reduce
performance or may cause a short.
Classification of check
Periodical
Daily
One
month
Three
month
Item Checking method Checking reference
Complete winch Operate the winch in and out
Minimum corrosion of the
internal motor components
Installation
Mounting bolts & alignment.
Bolts tension & wear. Tightened and aligned
Working Manual Reasonable actuation
Remote
control
Wearing in contact points Visual. Free of wear or damage.
Broken strands Visual, measuring (monthly)
Less than 10%
Decrease in rope diameter Visual, measuring (monthly)
7% of nominal diameter max
Wire rope
Deforming or corrosion and
fastening condition of end
Visual No existence of abnormalities
Freespool Wear in spring Visual evidence of wear Free of wear or damage.
Motor Staining, damage Visual evidence of wear No existence of abnormalities
Wearing of lining Visual evidence of wear Free of wear or damage.
Brake
Performance Visual Reasonable actuation
Gear train Damage, wearing Visual evidence of wear
Free of wear or damage and
distortion.
To Next Page
Loading...
