Model 2 Classic
7
3
Stand two long posts and slide a
short panel into the connector rings.
6
To add the next panel, li one of the con-
nector rings and use it to capture the new
panel. Assemble your lo by following the
conguration you have chosen (see page
14-15). Go slowly; it is not easy to replace
a panel aer a layer is placed on top.
5
Check the joints. Every panel should be
locked in place by four connector rings.
Repeat this step for each panel as you
build your lo.
4
Capture the panel by sliding another
connector ring onto each post, at side up.
To Next Page
