Assembly Instructions
Assembling your COMODITÀ Tipo Stand Up Rolling Walker is
extremely simple! You can also watch the assembly video at
www.comoditausa.com for more instructions.
1. Carefully remove the walker from the shipping carton.
2. Place the rollator on a flat surface.
3. Raise the handles to the upright position.
4. Lock the frame on both sides by bringing the folding lock
lever (pic 1) up 180 degrees, so it points up (pic 2). Turn
the folding lever 90 degrees towards the back wheel, so
it slides into the folding lock lever plastic support (pic 3).
Note: You can only slide the folding lock lever into the
plastic support if it is in the correct position, as seen in
the pictures below.
PIC 1 PIC 2 PIC 3.
3
To Next Page
Loading...
